 |
| This is a design sketch of the sculpture, showing it's basic shape and surface decoration. The sculpture will be 4'x4' |
 |
| The sculpture will be made of resin clay which hardens within 4 hours and is fully cured within 24hours. The armature was carefully designed and measured. |
 |
| This picture shows the armature from the bottom. The netting is necessary for the clay to grab onto. |
 |
| I laminated the Styrofoam then flipped the sculpture over and put clay on the bottom to harden. Then I finished building the armature in Styrofoam and wrapped it in the plastic mesh. A layer of plaster was then added. The picture above shows the steps. Starting at the top: carved Styrofoam, then plaster over the Styrofoam and at the bottom, the grey area is the resin clay. When finished the overall sculpture will be smooth. The texture you see in the clay at this time is there so the subsequent layers of clay will have something to "hold" onto. |
 |
| This is the making of the spout. I used a ceramic bowl as the form, draped it with wax paper so the clay would not stick and after placing it on the sculpture, closed the opening with clay. |
 |
| After many hours of work, it is finally shaping up. Very time consuming is the mixing of the clay but it gives me great pleasure when it hardens and I get closer to what the sculpture will be. |
